Overview

The DAT410 Inverter Assembly incorporates PTI's most advanced powerline interfacing logic. It builds off of the DAT210 platform but monitors more powerline variables and reacts with feedback loop utilizing relays and dry contacts for seamless integration into an industrial control cabinet.

Front Left
Front Right
Rear Right
Top
Connection Diagram
Top
Right Side
Left Side
Front
Back
DAT210 Set Power Point
DAT210 Start Button Sweep
DAT210 New Profile Procedure
DAT210 Normal Running
DAT210 LED Fault Indicators
DAT210 Connection Safety Considerations
DAT210 On Delay Timer
Fuse and Power Supply Testing
IGBT and Diode Bridge Testing
16 Pin Kit Testing
DAT210 Firmware 3 1
Installation Operation

Product Details

Benefits and Features of the Assembly

Supports 3Ø and 1Ø (substantially reduced power), mains: 460vac and 380vac (80% power).
Eliminates transient voltage spikes to DAT410 Inverter and Plasma Block Units
often caused by contact interruption at full power.
Includes DC rectification, power factor correction (.7 - .95 power factor), transient and line noise filtering. Absorbs transient energy from its specific load, not entire large system energy.
Processor managed soft-charge, pre-wired, inhibits a Run command until charge complete, manages mains transient drop-out and brown-out, open relay coil lock-out.
Soft start feature to prevent startup current surges from weakening circuit breakers and eliminating ozone cell thermal shock.
Output drive waveform configurable on the fly to accommodate primary or secondary side resonating inductor. Also supports non-resonant constant power loads.
Power factor correction to 0.95 results in excellent current harmonics mitigation.
Three phase 380 – 480vac 50/60hz rectification for single phase high frequency output.
10 KW rating (P/N 70328) for frequencies under 5khz, 4kw rating at 25khz.
DAT410 (Digital Auto Tuning) compensates automatically for generator changes in pressure, flow, line voltage fluctuations and excessive temperature.
No inverter and transformer failure due to brownout, operating changes or cell fault.
DAT’s wide range of power and frequency reduces OEM inventory.
Reduces expense of installing many components to achieve the same results.
Tested assembly reduces installation mistakes.
Complete electronics package required for ozone generators.
Reduces inverter mains current by about 50%, extends inverter component life

Connections

1.) Positive power output to DAT410 board. Connects to "+BUS" 0.25" quick connect tab on circuit board.
2.) Negative power output to DAT410 board. Connects to "-BUS" 0.25" quick connect tab on circuit board.
3.) Incoming 3 phase power. 0.25" quick connect tabs. Customer supplied fusing required.
4.) AC reference signal to DAT410 board. Connect to spades below these wires if single phase mains.

Plasma Technics, Inc.® (PTI) assumes no responsibility or liability for specific applications results.
PTI supplies only components for ozone systems and not the complete system. The complete system
is the responsibility of the ozone system manufacturer and/or others involved in a specific project.